Made it to 0G
My 0G CBR came in and I went to the piercer yesterday to have him put it in. I was at 2G for 10 months but I felt the 0 going in, it did sting for a second and I felt it the rest of the day. I guess I have to adjust now for a few days. I'm glad I waited and changed gauges slowly. I must say the 0 does feel amazing.
Are yourecovered yet? Is the new ring the same size as the old as in diameter but just a gauge up?Later,
Yes same diameter, I went from a 2G - 0G, I think that equates to 6.54MM - 8.25MM, or from 6mm - 8mm depending on which www you look at.
i need advice regarding this.... i have a pa and wanna size up but don't know how to go about it. how did you do it?
I took my time.
I started my PA 17Sep2012 at 8G titanium CBR. I remember I had a
problem at the beginning with a rim around the fistula but that
eventually settled down. 11Apr2013 I went to a 6G titanium curved
barbell. It was a change but the ball kept sliding into my urethra and
that wasn't always pleasant so I switched to a titanium circular barbell
and that solved the problem. I continue on 23Nov2013 and went to a 4G
titanium circular barbell, I though my journey would end here as it was
always my goal. Well, low and behold I went for a walk and one of the
balls fell off and say good bye to my jewelry. A quick visit on
30Jun2014 and instead of just replacing the 4G I went to a 2G titanium
circular barbell. Early 2015 while getting my guiche I was asking my
piercer about going to a 0, he checked and told me I had the room and
that when jewelry came in, they no longer stock 0G or anything larger,
that I should be fine to slip the 0 in. 09May2015 and my 0G titanium
CBR with a rubber ball is in, it did sting a bit when the piercer put it
in and was sore. Two days later and it is still a bit sore but I had
to take it for a test drive anyway, MMMMMM. So I'm back to using EMU
oil until the ring starts to slide on its own.
None of my gauge changes gave me any soreness except for the 2-0. I
never rushed anything and have always been good about doing SSS if I was
sore and then started using EMU oil if I was a little over anxious
during play time.
How did you make the hole bigger? Was it a taper that you used or was it gently forcing the new ring in? I have had mine about 4 months now and it's still the original pierced size and I wanna get some weight into it. It's also rather deep and I am hoping that if I can stretch it I can wear a smaller ring in it. Arm it's a 22mm ring cod when I get an erection it was pulling. I also wanna go to a curved bar. Tried it at the current size and it kept slipping in my urethra. If it's a larger size I am guessing in theory it would not slip in as much?
Actions
Back to TopicsReply to TopicShare this topic
Get paid just by sending us users/traffic.
Signup takes seconds, start now!
Signup as an affiliate!